Reading Time: 3 minutes
Q: Where Is the Starter Typically Located?
A: The starter is an electric motor that cranks the engine when you turn the ignition key. .Also called the starter motor, it mechanically engages and turns the engine flywheel.
You are viewing: Where Is The Starter
Your vehicle’s engine and transmission layout will determine the location of its starter. In a car, SUV, or truck with a front-wheel drive, the starter sits between the engine and transmission. You can find the starter motor below the engine’s left cylinder bank on the driver’s side.
Read more : Where To Buy Goat
For vehicles with rear-wheel drives, the starter is usually located below the exhaust manifold on the engine’s passenger’s side. A few models put their starter motor on top of the engine. In the latter arrangement, the starter lies underneath the intake manifold.
In the 2007 Ford Focus, the starter is mounted in front of the engine and over the oil filter. Meanwhile, Honda often mounts the starter under the intake manifold.
Tips On How to Access the Starter Motor
On some Chevy S10 platforms, the starter is so practically inaccessible that you can’t even see it. On many other platforms, it’s very easy to access and change. You need to carefully research the location of your starter before you even begin.
Read more : Where Can I Get Veneers Near Me
On some Honda four-cylinder engines, you have to remove the intake manifold to access the starter even though it’s down low on the front of the engine.
For one of the harder ones, on a 2007 Toyota Tundra V8, the starter is mounted on right the side of the engine at the back, but the labor time is over five hours at the dealer because it takes just about that long to do the job. Part of the exhaust has to be removed, some heat shields, etc.
Your first step should always be to disconnect the battery when trying to access the starter. Depending on your vehicle, you will need car jacks to lift it off the ground and access its underside unless the starter is mounted under the intake manifold. You also need sockets that match the size of the bolts of the hex nuts that secure the starter.
Source: https://t-tees.com
Category: WHERE
