My one coveted pair of touchscreen gloves, that came as swag in last year’s Run in the New Year 5k, were ‘accidentally’ carried off by my nephew at the end of that very cold but exciting night of college football back in November. I’ve put him on notice that I will be coming to retrieve them. But in the meantime, because I need to use my phone when bicycling and running in the cold, I experimented this week with diy options.
In searching online for diy touchscreen gloves, I learned about conductive thread, that can be purchased and knitted (or crocheted) onto the fingertips of an existing pair of gloves. The reviews are mixed. I have a hunch this is because people don’t make sure the thread goes all the way through to make good contact with both the fingertip and phone screen. I considered buying a spool of the conductive thread, which would have made a lot of touchscreen gloves. But then, I was at a Radio Shack store this past weekend, and happened to see this Graphite Conductive Glue. 
You are viewing: How To Make Touchscreen Gloves
I forked over $6 for the tiny tube, and came home to try it out. The result is, it was super easy and the gloves work great!
Here’s what I did:
Read more : How Do Fire Glove Straps Work
First, I protected my fingers with ordinary invisible tape, because the label says the glue can be a skin irritant.
Then I put the gloves on and carefully applied the glue in a circle on the forefinger and thumb contact points. I used a circular motion to embed the glue into the fibers and make sure it would go through to the other side of the knitted fabric. Conductivity from fingers to screen is the key, so a topical application of glue only on the outside of the glove won’t work. 
To further insure that the glue would penetrate to the other side of the fabric, I pressed my fingers together. I did this carefully, so as not to smudge the neat circles. (I did smudge them a bit on the first pair.) 
Read more : How To Make Ppe Gloves
Once I was confident in my technique, I applied the glue to my most favorite old pair of mittens. I’m happy with the result. 
The glue took about an hour to dry to the touch. Then I tested them on my tablet. They work very well! It’s now a few days later, and they are still working very well.
Here is a quick demo of my ‘new’ diy touchscreen gloves in action.
As you can see, I glued all of the fingers on the glove in the video. I think this was a waste of glue. I haven’t needed any fingers other than the thumb and forefinger for operating my phone and tablet.
About that skin irritation warning on the label…I suspect the warning applies only to the glue when wet. I’ve sensed no irritation from the dried glue whatsoever. But be careful; heed the warning and watch for signs of possible irritation on your own skin. And follow the label instructions. Here is the product MSDS sheet.
Additional notes:
- The dried glue circles are hard, and not flexible. I was able to restore enough of the fabric’s flexibility by gently bending and curling the dried glue tips.
- After doing a total of five gloves so far, I think there is still a lot of glue in the tube. So one $6 tube is enough to do quite a few gloves.
- How the glue will hold up in rain, snow or the washing machine is still an open question. I’ll report back when my gloves have been tested in wet conditions and laundering.
Source: https://t-tees.com
Category: HOW
