How to charge the Tesla Model 3
The Tesla Model 3 range uses the CCS charging standard, which consists of a combined AC and DC inlet port. The top portion of the inlet is for the Type 2 connector, which is used when charging at home, or at public slow and fast AC points. Both the upper and lower sections on the inlet are used to carry high power during rapid DC charging.
You are viewing: Where Is The Charge Port On A Tesla
Read more : Where Is The Drew Barrymore Show Filmed
In this case, the inlet is a Tesla-specific CCS, which means it can use the Supercharger and Destination charger networks. When using Superchargers, drivers will need to use tethered CCS adaptor, rather than the Type 2 connector from the unit. The Model 3 will be able to charge from Tesla Destination units in the same way as Model S and Model X drivers.
The Tesla Model 3’s CCS charging inlet is found on the rear near-side flank, built into the leading section of the rear light cluster. The Model 3 is able to be slow, fast and rapid charged from public points, depending on the network and type of charge unit. In most cases, slow charging requires a 3-pin-to-Type 2 cable, and fast charging a Type 2-to-Type 2 cable, one of which is usually supplied with the vehicle. For rapid charging, the vehicle uses a tethered CCS connector which is part of the charging unit.
Read more : Where Can I Buy Fill Dirt
The Tesla Model 3 uses two charging standards for its inlets – Type 2 and CCS. The Type 2 inlet is used when charging at home or at public slow and fast AC points. The CCS inlet is used to carry high power during rapid DC charging from a CCS connector.
Charging on AC or DC requires the EV driver to plug the connectors into the correct inlet, after which the car then ‘talks’ to the charging unit to make sure there is a power supply, that there are no faults, and that it is safe to start charging. If charging at home or at a workplace charge point, the vehicle then automatically starts charging.
On a public charger, an activation process is required to initiate charging. Depending on the network provider, this may involve the use of Zap-Pay, an RFID card or a smartphone app, often linked to an account which has been set up beforehand. Contactless pay-as-you-go units are also becoming more common on newer units. Once activated, the units will conduct further connection and account checks before starting to charge the vehicle.
Source: https://t-tees.com
Category: WHERE
