In this irrigation design tip, we’ll review the selection criteria needed to inform your decision on which spray, rotors, and/or drip components for the project.
Most of the selection criteria uses the site-specific information gathered or calculated in the earlier steps such as: water source, water pressure, soil type, climate and determining the irrigation requirement. Selecting irrigation components without first gathering this information is premature and can lead to an irrigation system that does not perform to meet the landscape’s requirements and can cause significant performance and maintenance problems.
You are viewing: Which Rain Bird Nozzle Should I Use
In previous Irrigation Design Tips, we identified required information that you need to gather before the selection process begins. Here’s a quick review.
1. Water supply and pressure, and flow limit
Each type of component has a performance range for proper operation and these ranges must fit within the available flow and pressure criteria, both of which are a function of the water supply.
2. Climate
Read more : Which Activities Do Accounting And Finance Components Perform
Areas with special climatic conditions will require special components. Windy areas may demand low-angle nozzles that keep the water near the ground where it resists being blown away. Landscapes in arid climates which experience excessive heat may need either higher flow nozzles or multiple irrigation cycles to maintain the plant material.
3. Soil type and terrain
The application rate cannot exceed the soil’s ability to accept water. Low precipitation rate (PR) nozzles may be required to adjust the rate of water application to the intake rate of the soil. Also, low PR nozzles or dripline can be used on slopes to reduce the potential for runoff and erosion.
Additional Considerations
In addition to any special request by your client or property owner, here are some additional points of consideration when selecting the right components for your project:
1. Size and shape of the areas to be watered.
The goal is to select the type of device that will cover the area properly using the least number of units.
2. Types of plant material to be irrigated also dictates which type of component is to be used.
Read more : Which Statements Characterize The Microscopic Arrangement Of Spongy Bone
Lawns, shrubs, trees and ground covers may all require different types.
3. Protection of hardscapes or other structures that can’t tolerate overspray.
4. Compatibility of the components used on the same valve.
Compatibility is particularly important when laying out laterals or circuiting sprinklers into groups that will be served by the same valve. You want to avoid mixing components with different precipitation rates on the same valve whenever possible. When components with varying precipitation rates are on the same valve, the owner or maintenance personnel are required to over water one area to sufficiently water another. Even the same type of components may require separate valves to match up water application rate with the rest of the components.
Using matched precipitation nozzles (MPR) allow the same type of sprays or rotors, no matter what arc they cover, to be circuited on the same valve and deliver the same precipitation rate.
MPR nozzles discharge proportional flows of water that match the arc or part of a circle they cover. A full circle nozzle discharges twice the flow of a half circle nozzle and a quarter circle nozzle discharges half of what the half circle unit does. Some nozzles, such as Rain Bird’s Rotary Nozzles have matched precipitation rate with 5000 MPR rotor nozzles – in this case you can use an 1800 Series spray with a Rotary Nozzle on the same valve as a 5000 rotor with MPR nozzle.
Source: https://t-tees.com
Category: WHICH
