Which Way Does Crush Washer Go - T-Tees - Your Answers Await, Life's Questions Unraveled

Let’s get a couple of things out of the way;

You may be interested

1. NEVER use a crush washer with a suppressor!!!(see #2)

You are viewing: Which Way Does Crush Washer Go

2. A crush washer is technically NOT a washer, it is a cone shaped spring. (the added length and mass of a suppressor can compress one side of the spring under recoil/barrel flexing, causing a coaxial misalignment and in turn, baffle strikes. The low weight and shorter length of a brake precludes this.)

3. A properly installed crush washer should NOT harm accuracy. We have yet to see any evidence of accuracy degradation in 100’s of groups and rifles tested.

4. The threading of a muzzle requires a certain amount of tension for the muzzle to maintain structural integrity. The geometry of the threads not only pull against one another, but the also exert compressive force towards the bore.

5. The Engineering hierarchy of “timing” a brake from best to least is: Direct brake to barrel contact at the shoulder via gunsmithing or CWES style bushing system(no chance of coaxial misalignment). Precision Shims(least chance but adds extra mating surfaces). Crushwasher(Not the best from an engineering standpoint, but has proven reliability). Adapter(Risk of stacked tolerances, too many mating surfaces/angles). Jam-nut/Lock-nut(will actually force coaxial misalignment if torqued enough to prevent vibrating loose).

Refer to more articles: Which President Made This Pledge To Veterans

Now onto the how-to, and some of the why’s:

Start by making sure that the threads of the muzzle device and barrel are relatively clean, and free of dirt, carbon, etc.

Next, apply a dab of grease on the washer to reduce rotational friction while turning (it’s the spring tension that does the work of holding the brake in place and maintaining pressure).

Direction of crush washer is one of the most common questions, the correct answer is that the contact diameter of the washer needs to be the same or smaller that the surface it mates against, in some cases that’s cone forward, in others it’s cone towards shooter, and in others it doesn’t actually matter.

Place the crush washer over the muzzle threads, then thread the muzzle device up against the crush washer, hand tight.

Using a wrench, socket, or other suitable tool, Turn the Brake 1/4turn/90degrees PLUS enough to clock it properly. (Proper crush washers are machined from spring steel and will compress, and at 1/4turn will reach and maintain a rotational torque of 20-28ft/lbs until completely flat. This is the torque value that will ensure the thread profile applies the correct range of compression to the muzzle threads).

• Check with the Firearm Manufacturer whether the firearm is designed to be used with a Muzzle Brake • Never use SABOT or SHOTSHELLS in conjunction with a Muzzle Brake, or fireform with “cream of wheat” with brake installed • Before shooting, check the correct torque of the clamping screws and the position of the Muzzle Brake. With long shot strings, carry out this check periodically ( approx. every 50 shots) • The propellant gases, including particles of unburned powder, dust and or moisture will be accelerated – exhausted sideways from the Muzzle Brake  Safety Distance min. 1yd  Wear Ear Protection  Wear Eye Protection

Refer to more articles: Which Is Lighter Aluminum Or Titanium

Source: https://t-tees.com
Category: WHICH